15 Search Results

Removal of gases and particles by precipitation (wet deposition) is a critical process that significantly influences the transport and chemical transformation of atmospheric compounds. However, there are few studies that directly measure or constrain the rates of this process under real-world conditions. This work quantifies the net change in ambient concentrations during precipitation events (removal rates) of gas- and particle-phase organic compounds at a surface site near Manaus, Brazil, during the GoAmazon2014/5 campaign. Removal rates of identified and unknown compounds that have been previously classified into source-based clusters are measured during rain events and categorized based on estimated properties ofmore » compounds and clusters. Highly oxygenated gases, such as isoprene oxidation products, are removed during precipitation events with a median removal rate of 0.09 h^–1 and the fastest analyte is removed at a rate of 0.22 h^–1. Removal rates of particle-phase compounds are observed at roughly this median rate, while less soluble gases, such as terpenes, exhibit low removal rates. These results are roughly in agreement with prior theoretical estimates of wet deposition rates for comparable compounds, providing an empirical point of comparison while noting that our metric reflects the net influence of precipitation events rather than wet deposition alone.« less

Chlorinated paraffins (CPs) are synthetic polychlorinated n-alkanes produced as mixtures of a range of C_xCl_yH_2x–y+2 formulas. CPs have numerous industrial applications but are toxic, long-lived, and environmentally ubiquitous with environmental releases occurring throughout their production, use, and disposal. Short-chain chlorinated paraffins (SCCPs, C_10–13) have been regulated by the United States Environmental Protection Agency since 2009 and by the Stockholm Convention since 2017. SCCP regulation is expected to cause increased production of medium-chain chlorinated paraffins (MCCPs; C_14–17), which are currently under consideration for Stockholm Convention regulations. Thus, there is a need to improve the understanding of MCCP environmental transport, distribution, andmore » fate. Existing measurements are limited in their spatial and temporal coverage. Measurements of CP atmospheric loading are particularly scarce. Historically, these measurements have required long sampling times, obscuring the temporal behavior of atmospheric CPs. We report real-time in situ measurements of 18 gas-phase MCCPs. These measurements were made in the United States Southern Great Plains with nitrate ion chemical ionization mass spectrometry (NO₃–CIMS). Here, the estimated average lower-limit concentration of MCCPs is on the order of single-digit ng/m³. MCCP diel behavior is partially explained by gas-particle partitioning with implications for MCCP transport and lifetimes.« less

Mass spectrometry (MS) has become an essential tool in virtually all academic, pharmaceutical, and biopharmaceutical analytical laboratories. The specialized and bespoke area of MS research and application of high m/z ion (>m/z 6000 and high mass, >150 kDa) formation, transmission, analysis, and detection is a relatively new area of focus for MS that has seen dramatic acceleration in interest over the last two decades. Herein we delve into this exciting aspect of MS, discussing how MS instrumentation has been refined and evolved for native-MS analysis. We cover the early groundbreaking experiments showing high m/z ion formation, transmission, and preservation ofmore » protein structure in the gas phase. Additionally, we discuss specific instrument optimizations and modifications that have advanced high m/z ion generation, transmission, analysis, and detection, contributing to the research area known as gas-phase structural biology. Native-MS sample introduction methods, emerging technologies, and future perspectives are also examined. Finally, we share personal opinions, observations, and experiences that are new to the community or previously unpublished.« less

In this work, we report on defect generation in multilayer GaSe through hydrostatic pressure quenching and UV laser irradiation. The Raman line width from the UV 266 nm irradiated sample is much wider than that in pressure-quenched GaSe, corresponding to a wider defect energy distribution range in the former sample than the latter. After quenching from 11.2 GPa, three photoluminescence (PL) peaks from defect states are observed at 657, 681, and 695 nm at a low temperature of 93 K. Defect-related peaks at 649, 694, 750, and 774 nm also appear in low-temperature PL spectra after UV laser irradiation, withmore » a nonmonotonous intensity dependence on irradiation duration. There are common features in defects produced by these two methods: the PL peaks with the lowest energy are sharp, and their PL intensities increase linearly with the excitation laser power and saturate above a certain excitation laser power. These two features are similar to those in defects for single-photon emission (SPE) in other 2D materials at even lower temperatures. Fluorescence lifetime imaging shows distinguished short (2.3 ns) and long (75.6 nm) lifetimes of the 695 nm PL line in pressure-quenched GaSe. The density functional theory predicts defect energy levels related to Se vacancy.« less

Nanoscale strain control of exciton funneling is an increasingly critical tool for the scalable production of single photon emitters (SPEs) in two-dimensional materials. However, conventional far-field optical microscopies remain constrained in spatial resolution by the diffraction limit and thus can provide only a limited description of nanoscale strain localization of SPEs. Here, we quantify the effects of nanoscale heterogeneous strain on the energy and brightness of GaSe SPEs on nanopillars with correlative cathodoluminescence, photoluminescence, and atomic force microscopy, supported by density functional theory simulations. We report the strain-localized SPEs have a broad range of emission wavelengths from 620 to 900more » nm. We reveal substantial strain-controlled SPE wavelength tunability over a ~100 nm spectral range and 2 orders of magnitude enhancement in the SPE brightness at the pillar center due to Type-I exciton funneling. In addition, we show that radiative biexciton cascade processes contribute to observed CL photon superbunching. Also, the GaSe SPEs show excellent stability, where their properties remain unchanged after electron beam exposure. Importantly, we anticipate that this comprehensive study on the nanoscale strain control of two-dimensional SPEs will provide key insights to guide the development of truly deterministic quantum photonics.« less

Magmatic gas exsolving during late-stage cooling of shallow magmas has been considered an important facilitator of low-pressure alteration and metal transport. However, the chemical properties of such gas, particularly its metal transport mechanisms and capacity, remain elusive. Trace elements in minerals produced by gas-mediated surface reaction or precipitation from gas capture details of gas composition and reaction pathways. However, interpretation of mineral trace element contents is dependent on understanding crystallographic controls on gas/mineral partitioning. Here, this work investigates the structural accommodation of As, Mn, Ga, Ge, Fe, and Ti in vapor-deposited topaz of vesicular topaz rhyolite from the Thomas Range,more » Utah, through single-crystal synchrotron microbeam X-ray techniques on picogram quantities of those trace elements. X-ray absorption near edge structure (XANES) data indicates that these elements are incorporated into topaz as As⁵⁺, Fe³⁺, Mn³⁺, Ti⁴⁺, Ga³⁺, and Ge⁴⁺. Extended X-ray absorption fine structure (EXAFS) analysis for these trace elements, compared to EXAFS of structural Al and Si, reveals that As⁵⁺ and Ge⁴⁺ are incorporated directly into the tetrahedral site of the topaz structure, with the octahedral site accommodating Mn³⁺, Fe³⁺, Ga³⁺, and Ti⁴⁺. For As⁵⁺ and Fe³⁺, the structural impact of substitution extends to at least second neighbors (other elements were only resolvable to first neighbors). Further interpretation of the EXAFS results suggests that the substitution of Ti⁴⁺ results in increased distortion of the octahedral site, while the other trace elements induce more uniform expansion correlating in magnitude to their ionic radius. Comparison of quantified X-ray fluorescence (XRF) data for two topaz crystals from this rhyolite reveals variable trace element concentrations for As⁵⁺, Fe³⁺, Ga³⁺, and Ti⁴⁺, reflective of a source gas undersaturated in these trace elements changing in concentration over the period of topaz deposition. The identical Ge⁴⁺ content of the two topaz crystals suggests that Ge⁴⁺ in the gas was buffered by the growth of another Ge⁴⁺-bearing phase, such as quartz. The very low Mn³⁺ content in the topaz crystals does not reflect the abundance of Mn³⁺ in the gas (saturation of Mn is evidenced by coexisting bixbyite). Instead, it suggests a strong Jahn-Teller inhibitory effect to the substitution of Mn³⁺ for Al³⁺ in the distorted octahedral site of topaz. It is proposed that exsolution of an HF-enriched gas from cooling rhyolitic magma led to local scouring of Al, Si, and trace metals from the magma. Once topaz crystals nucleated, self-catalyzed reactions that recycle HF led to continued growth of topaz.« less

Exciton localization through nanoscale strain has been used to create highly efficient single-photon emitters (SPEs) in 2D materials. However, the strong Coulomb interactions between excitons can lead to nonradiative recombination through exciton–exciton annihilation, negatively impacting SPE performance. Here, we investigate the effect of Coulomb interactions on the brightness, single photon purity, and operating temperatures of strain-localized GaSe SPEs by using electrostatic doping. By gating GaSe to the charge neutrality point, the exciton–exciton annihilation nonradiative pathway is suppressed, leading to ∼60% improvement of emission intensity and an enhancement of the single photon purity g⁽²⁾(0) from 0.55 to 0.28. The operating temperaturemore » also increased from 4.5 K to 85 K consequently. In conclusion, this research provides insight into many-body interactions in excitons confined by nanoscale strain and lays the groundwork for the optimization of SPEs for optoelectronics and quantum photonics.« less

Hydrogen-fueled microturbines are being considered as part of the future green microgrid. However, the use of hydrogen as a fuel presents new challenges for selection and development of suitable high temperature materials for hydrogen combustion. The burning of hydrogen is expected to result in higher operating temperatures and higher than typically observed water vapor contents in exhaust gases versus burning natural gas. In the present work, foil specimens of various Fe- and Ni-based alloys were oxidized in air + 10 % H₂O and air + 60% H₂O for up to 5,000 h at 700 °C to simulate the exhaust atmospheremore » of natural gas and hydrogen-fueled microturbines. Here, the impact of alloy composition and water vapor content on the oxidation/ volatilization induced loss of wall thickness was experimentally evaluated. Enhanced external oxidation and volatilization of Cr₂O₃ and Ti-doped Cr₂O₃ scales was observed in air + 60% H₂O compared to air + 10% H₂O. No significant impact of the higher water vapor content was observed on Al₂O₃ scales formed on Fe-based alumina forming alloys. Lifetime modeling was employed to predict the combined effects of water vapor content, gas flow rates, temperature and alloy composition on the oxidation-induced lifetime of the investigated materials.« less

The nanoscale strain has emerged as a powerful tool for controlling single-photon emitters (SPEs) in atomically thin transition metal dichalcogenides (TMDCs). However, quantum emitters in monolayer TMDCs are typically unstable in ambient conditions. Multilayer TMDCs could be a solution, but they suffer from low quantum efficiency, resulting in low brightness of the SPEs. Here, we report the deterministic spatial localization of strain-induced SPEs in multilayer GaSe by nanopillar arrays. The strain-controlled quantum confinement effect introduces well-isolated sub-bandgap photoluminescence and corresponding suppression of the broad band edge photoluminescence. Clear photon-antibunching behavior is observed from the quantum dot-like GaSe sub-bandgap exciton emissionmore » at 3.5 K. The strain-dependent confinement potential and the brightness are found to be strongly correlated, suggesting a promising route for tuning and controlling SPEs. The comprehensive investigations of strain-engineered GaSe SPEs provide a solid foundation for the development of 2D devices for quantum photonic technologies.« less

This article discusses from a personal and present-day perspective the first studies of large highly charged individual molecular ions that were conducted using electrospray ionization (ESI) with Fourier transform ion cyclotron resonance (FTICR) MS in the mid-1990s. These studies are distinguished from current Charge Detection Mass Spectrometry (CDMS) research primarily by their use of individual ion charge state changes due to reactions. Here this work describes the key differences in technologies and methods with present CDMS, and the likely implications of these differences. I also comment on surprising individual ion behavior observed in some measurements involving increases in charge state,more » as well as their possible basis, and also briefly discuss the potential utility of the reaction-based mass measurement approach used in the context of what might more globally be referred to as ‘Charge Determination Mass Spectrometry’.« less